The JLD505 module consists of a single two-layer printed circuit board mounted in a
Modice Cinch LE weatherproof enclosure.
This module is compatible with the Arduino Uno multicrontroller board and uses the
Arduino Integrated Development Environment for programming.
The heart of the module is an ATMEGA328P-AU 16 MHz multicontroller. The highperformance Atmel picoPower 8-bit AVR RISC-based microcontroller combines 32KB ISP flash memory with read-while-write capabilities, 1024B EEPROM, 2KB SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible timer/counters with compare modes, internal and external interrupts, serial
programmable USART, a byte-oriented 2-wire serial interface, SPI serial port, a 6-
channel 10-bit A/D converter (8-channels in TQFP and QFN/MLF packages),
programmable watchdog timer with internal oscillator, and five software selectable power saving modes. The device operates between 1.8-5.5 volts.
By executing powerful instructions in a single clock cycle, the device achieves
The EVTV CHAdeMO Fast Charge Kit includes the following components:
• 1 CHAdeMO Fast Charge Inlet and wiring harness.
• 1 JLD505 Charge Controller
• 1 Cinch Connector and Pin Set
• 2 Gigavac High Voltage Contactor Relays
• 1 12v Relay
• 1 DS18B20 Temperature Sensor Probe
• 1 400A 50mv 0.1% calibrated shunt
• 1 USB Connection Cable